Zone Readiness Shows Error

Zone readiness runs every 15 minutes.  If you made a change make sure to run the DR readiness job as the DR Dashboard is updated for zone readiness on a scheduled interval.


  1. Open job icon
  2. scroll down to DR readiness jobs 
  3. Select any one of the listed jobs
  4. Bulk actions 
  5. Run now
  6. All clusters and zones will be validated
  7. Monitor job from running jobs tab (job icon)
  8. Once complete
  9. check DR Dashboard for updated status


If your zone shows an error use this link to review each validation error or warning to understand the steps to remediate the configuration validation error.


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request


Powered by Zendesk